Contact us direct for fast friendly service (800) 477-1255
9117-CA
1/4"-20 X 1"
SLOTTED HEAD SCREW
1/4"-20 HEX NUT
#8-32 x 3/8"
FLAT HEAD TAPPING SCREW
1.) BEFORE INSTALLING MODULAR DRAWER UNITS, IT MUST BE
VERIFIED THAT THE UPRIGHTS ARE PLUMB AND THE SHELVES
ARE LEVEL. THE SHELVING UNIT MUST ALSO BE PROPERLY
ANCHORED AS DESCRIBED IN THE INSTALLATION SHEET
PROVIDED WITH THE SHELVING UNIT. IF NEEDED, CONTACT
REPUBLIC CUSTOMER SERVICE FOR PROPER ANCHORING
METHODS. DRAWERS WILL NOT OPERATE CORRECTLY IF THE
ABOVE CRITERIA IS NOT MET.
2.) EACH UNIT MUST HAVE A SHELF ABOVE AND BELOW THE UNIT.
TWO UNITS IN ONE SHELVING SECTION MUST BE SEPARATED BY
A SHELF. THE SHELF SPACING FOR EACH UNIT IS 1 1/2"
GREATER THAN NOMINAL. EXAMPLE: ONE 24" UNIT (30
SEGMENTS) REQUIRES A SPACE OF 25 1/2". THIS SPACE IS
MEASURED FROM TOP OF SHELF TO TOP OF SHELF.
3.) MODULAR DRAWERS ARE AVAILABLE IN THE FOLLOWING SIZES:
ANY COMBINATION OF DRAWER SEGMENTS TOTALING 15 FOR
THE 12" UNIT, 22 FOR THE 18" UNIT, 30 FOR THE 24" UNIT OR 45
FOR THE 36" UNIT MAY BE USED
REAR BRACKETS
(2 PIECES)
FRONT BRACKETS
(2 PIECES)
HORIZONTAL TRIM
(1 PIECE)
(4 PIECES)
(4 PIECES)
(2 PIECES PER DRAWER)
SHEET 1
PANEL CLIP
(2 PIECES)
LH
RH
LH
RH
