Lynx RaveTM 600, Руководство оператора

Страница: 114 / 134

Typ11
TYPICAL
1. Adjustment bolts
2. Loosen bolt
– Retighten retaining bolts.
– Check track alignment as described
below.
Alignment

WARNING
Before checking track alignment,
ensure that the track is free of all
particles which could be thrown
out while track is rotating. Keep
hands, tools, feet and clothing
clear of track.
Always lift the
snowmobile on a wide-base stand
with a rear deflector panel.
En-
sure no one is standing in close
proximity to the snowmobile, es-
pecially at the rear of the track.
Never rotate track at high speed.
Centrifugal force could cause de-
bris, pieces of torn track, or an
entire severed track to be violent-
ly thrown backwards out of the
tunnel
with tremendous force,
possibly resulting in the loss of a
leg or other serious injury.
Start the engine and accelerate slightly
so that track barely turns. This must
be done in a short period of time (15
to 20 seconds).
Check that the track is well centered;
equal distance on both sides between
edges of track guides and slider shoes.
A01F05A
1
2
3
1. Guides
2. Slider shoes
3. Equal distance
To Adjust Track Alignment:

WARNING
Remove the tether cord cap (DESS
key) before performing any main-
tenance or adjustment, unless oth-
erwise specified. Vehicle must be
parked in a safe place, away from
the trail.
– Remove the tether cord cap (DESS
key).
– Loosen rear idler wheel retaining
bolts.
– Tighten the adjustment bolt on side
where the slider shoe is the farthest
from the track insert guides.
A01F0BA
1
2
3
1
1. Guides
2. Slider shoes
3. Tighten on this side
Tighten retaining bolts.
112
_____________________