LX-318C
LYNX Pro Audio S.L. -
Valencia, Spain -
www.lynxproaudio.com [email protected]
Select and run a preset.
To change the preset configuration just press the up button (1) and down button (2) until you see the title
and present number required. Once found, press OK (3) until the progress bar finishes (Fig3). The display will
indicate “Loading DSP” (Fig4)
Configuring the Cabinet DSP options.
From the buttons below the display on the Lynx cabinet’s back panel you are able to configure the Basic
adjustment functions of the internal DSP.
Note:
You must apply the desired configuration in each cabinet. This is done via the buttons located on the back
panel of the cabinet and requires electrical power to work.
Configuration Panel.
On the back panel you will see 3 buttons and an information screen, on which you can read the established
parameters and information such as amplification module temperature, input signal level and name of the current
preset (Fig1). If changes are not made the display will automatically dim to save energy and avoid unnecessary
light in situations where light is not wanted. To re-activate the light simply press the OK button.
9
Fig 1
