10
CARE AND USE/INSTALLATION
USING YOUR BEVERAGE DISPENSER
Your dispensing kit includes the following parts:
Polished stainless steel tower with clear beverage line
(single
or double dispense)
Tower Gasket
Phillips oval head screws
Knob for Tower (Faucet Handle)
Keg coupler(s)
Gas regulator with red gas line(s) attached
Empty 5 pound gas tank
Plastic clamp(s) large and small
Faucet wrench
Tools required for installation:
Flat bladed screwdriver
Phillips screwdriver
Pliers
Adjustable wrench or a 1
1
⁄
8
" open end wrench
1
⁄
2
" open end wrench
Barrel Sizes
1/6 barrel
1/4 Barrel
1/2 Barrel
Height
23
5
⁄
16
"
(59.2 cm)
14
13
⁄
16
"
(37.6 cm)
23
5
⁄
16
"
(59.2 cm)
Diameter
9
1
⁄
4
"
(23.5 cm)
17"
(43.2 cm)
17" to 17
1
⁄
4
"
(43.2 to 43 cm)
Gallons
5.16
7.75
15.5
#12 ounce
Glasses
60
82
163
This beverage dispensing unit will support one half (
1
⁄
2
) bar-
rel or one quarter (
1
⁄
4
) barrel. The double draft tower units
can support two sixth (
1
⁄
6
) barrels of beverage. See chart
below for quantity of beverage in each barrel size.
Table A
Table B
Keg Size
#of kegs per
5 pound Gas Tank
5 gallon Corny
15 to 22
1/6 barrel
14 to 21
1/4 Barrel
10 to 14
1/2 Barrel
5 to 7
CO
2
and N
2
can be dangerous. If it becomes dif
-
ficult to breathe and/or your head starts to ache,
a high concentration of carbon dioxide may be
present. Leave the area immediately.
•
The gas tank must always be connected to the
regulator.
Never
connect the tank to the keg.
•
The gas tank must be securely mounted in the
upright position. Secure it with the chain pro-
vided.
•
Never
drop or throw the gas tank.
•
Keep the gas tank away from heat.
•
Ventilate the area after a gas leak.
!
WARNING
1. Remove shelving and packaged components from the
interior of the refrigerator before beginning the assem-
bly process.
2. Take your empty 5 pound gas tank to your local gas
supply dealer to be filled. You can usually find them in
your "yellow pages" under "Welding Supply" or "Fire
Protection". One 5 pound tank can process many kegs
(see Table B).
3. Tower mounting (if you are installing the unit under a
counter skip to step 4). If you are mounting the tower
directly to the top of the refrigerator, first remove the
four screws from the top of the refrigerator. Remove the
foam plug from the large hole in the top of the refrig-
erator. Feed the clear beverage line through the tower
gasket and the large hole in the refrigerator top. Align
the 4 holes in the tower with the 4 holes in the refrigera-
tor top and secure the tower with the 4 screws removed
previously. Skip to step 5.
Tap Equipment and Assembly
