Reference Manual C AD 3110 -2 Version1.3
Page 17
Switch Function Detail
Dip Switch 1
Enables or disables local control
ON
this will enable local control
OFF
this disables local control, the module can only
be controlled via remote control
Dip Switch 2
Studio Quality input or Low Quality input. When set
to
ON
this will set the internal PLL to use a VCXO for
low jitter mode. When set to
OFF
this enables the
PLL to follow low quality inputs
Dip Switch 3
Test on / off select. When set to
ON
this will insert
the internal test signal which will then be present on
the SDI outputs. When set to
OFF
this will pass the
input video signal. Switching twice within two
seconds activates the next pattern in the following
sequence: - color bars – color bars over red – black
signal – PLL/EQ pathological.
Dip Switch 4
CVBS or YUV input select. When set to
ON
This sets
the module to convert CVBS (composite) inputs.
When set to
OFF
the YUV (component) input mode
is selected.
Note
. Switch 4 must be set to
OFF
to
make switch 3 active.
Dip Switch 5
S-Video select. When set to
ON
this will enable the
S-Video input (Luma / Chroma). When set to
OFF
,
this will enable the selection made on Switch 3.
Dip Switch 6
CTI – Color Transition Improvement. This function
improves the sharpness of color transitions
depending on the contrast. When set to
ON
this will
enable CTI. When set to
OFF
, this will disable CTI.
