a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | p: 801-822-5450
User Guide
9
The XAP-1030 has four LEDs, positioned horizontally on the bottom right side of
the front of the access point. When viewed left to right, LEDs are as follows: 1)
Power (Green); 2) LAN Link/Activity (Amber); 3) WLAN Status (Blue); and 4) Bridge
Mode (Green).
The following table describes the LED functionality:
Indicator Name
Description
Bridge Mode
On
Bridge is connected
Flashing
Bridge Mode enabled but not connected
Off
The AP is in default “Access Point” mode.
WLAN Status
On
The wireless radio is active and wireless
access is enabled
Off
The wireless radio is not active and wireless
access is disabled
LAN Link/Activity On
There is an active Ethernet connection
Flashing
Indicates Ethernet activity
Off
There is no active Ethernet connection
Power
On
The power is on
Off
No power, check power connections
At startup, the Green Power LED will stay on while the amber LAN Link light
fl ashes. The blue LED will come on once the XAP-1030 wireless radio is active.
4.2 Top View
The Top of the XAP-1030 provides one SMA antenna connector and one RJ-45 con-
nection that is used to deliver both power and data to the access point.
XAP-1030 Top View
4.3 Rear View
The Rear of the XAP-1030 has two key holes to allow for easy and fl exible mounting
on a wall or other solid surface. For desktop or shelf mounting, it also has guides
for placement of the four rubber feet provided.
