User Guide
14
© Copyright 2014 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
4.5.4 Connecting to the Internet Source
Note that the Luxul device is not a router and in most installations will be con-
nected to a Router or Switch in order to deliver Internet access. To do so, connect
the POE injector (or switch) to the desired Internet source using another Ethernet
cable. Be sure the source device is powered off.
POE
Injector
Power
Source
Power
In
Ferrite Noise
Suppresser
Data
Source
Poe
Device
Data/Pwr
Out
Data
In
The POE Injector Sends Power and Signal Over One Ethernet Cable
4.5.5 Applying Power
Once the Ethernet cables have been properly connected, connect the power sup-
ply to the POE injector and plug it in to a standard AC power outlet. Or, if plugging
into a POE switch, turn the switch (or appropriate port) on. The network source
device can also now be powered back on.
NOTE:
If your Internet source (Router or Switch) is a POE enabled device
and connected via POE, it can be plugged directly into the access
point without the need to run a separate POE injector.
4.5.6 LED Visual Verifi cation
With power applied, you can now verify that the XAP-1020 is connected and
functioning properly by performing a visual inspection of the LEDs. When looking
through the viewing portal (facing the front of the unit), the Green Power LED at
the right should be on while the amber LAN Link light fl ashes, indicating Ethernet
activity. Once the WLAN LED is solid blue the XAP-1020 is ready to receive con-
nections from wireless devices. The Green LED at the the left will only be on if the
access point is set to function in bridge mode.
