QUICK InSTALL GUIdE
AssEMbLE ThE RAnGE ExTEnDER KIT
1. Position the mounting board with the four holes for
the signal booster at the bottom of the board and the
three holes for the antenna mount at the right side of
the board.
2. Attach the Shock-WAV Signal Booster and antenna
mount to the pre-drilled holes in the mounting board
using the screws provided.
3. Attach the antenna to the mounting bracket by
turning it in a clockwise motion until it stops. Don’t
over tighten. The adjustable antenna mount will allow
setting the antenna angle.
4. Mount the AP to the mounting board using the
included Velcro mounting strips.
ConnECTInG ThE CoAx CAbLEs
1. Connect the X-WAV antenna to the Shock-WAV Wi-Fi
Signal Booster using the N-Male to N-Male cable. Be
sure to connect the cable to the side of the Shock-
WAV Wi-Fi Signal Booster labeled “Antenna”.
2. Remove the stock antenna from your AP. Set aside the
stock antenna, you will not need it for this installation.
3. Using the included N-Male to RP-SMA cable connect the
Shock-WAV Wi-Fi Signal Booster to the antenna port of
your AP. Be sure to connect the cable to the side of the
Shock-WAV Wi-Fi Signal Booster labeled “INPUT”.
PoWERInG oPTIons
For maximum flexibility you may power the Pro-WAV Board Mounted Range Extender Kit by
Direct Power or POE using the optional Luxul Wireless POE Injector or a POE injector that
supports legacy mode. The Luxul Wireless Signal Booster does not support 802.3af POE
power. (Check POE’s documentation).
INPUT
POE
OUT
POE
IN
ANTENNA
48V
DC IN
FIGURE 1
FIGURE 2
INPUT
POE
OUT
POE
IN
ANTENNA
48V
DC IN
