8
4.3 ConneCting PoWer And dAtA SourCe CAbleS
WARNING!:
Do not attempt to connect or disconnect any components while the
D-Link DWL-2100AP WAP or Shock-WAV signal booster are plugged
into power. Doing so may cause equipment damage and/or physical
injury and will void your warranty.
Figure 4
3
1
2
Power Supply
Coax Cable
Ethernet
Power
Data Source
Power
Power connections are the same for both PW-FC1 units. The PW-FC1 - Single antenna is show in
figure 4. Connect your Data source Ethernet cable to the LAN port on the back of the D-Link
DWL-2100AP, (Figure 4)
1
.
Connect the D-Link Power supply the power port on the back of
the DWL-2100AP
2
. Connect the 48V AC-DC power supply to the Signal Booster port labeled,
12-48V DC IN
3
. Plug the power supplies into your 100-240V compatible power source.
(ConsultyourD-LinkDocumentationformoreinformationontheDWL-2100AP).
5 - AntennA PlACement
Luxul Wireless products, particularly those implementing our patented signal booster technology,
are often capable of emitting enough signal strength to cover the desired area regardless of
orientation. For best results, the Antenna should be deployed where the maximum amount of
signal can be sent throughout the desired coverage area.
