ShocK-WAV SiGnAl booStER USER GUidE
7
4.1 ConneCting tHe PW-FC2 - Single AntennA to tHe netgeAr Wg103
Figure 2
Coax Cable
2
3
4
5
1
Using the supplied N-Male to RP-SMA-Male coax cable, connect the Shock-WAV Wi-Fi Signal
Booster to your WG103’s Antenna port . (Figure 2 )
1
. Be sure to connect the cable to the
side of the Signal Booster labeled WAP
2
. Next use the included N-Male to N-Male cable
3
connect the Shock-WAV Wi-Fi Signal Booster
to the X-WAV XW-24-FP7 antenna
5
. Be sure to
connect the cable to the side of the Signal Booster labeled Antenna
4
.
4.2 ConneCting tHe PW-FC2 - duAl AntennA to tHe netgeAr Wg103
Figure 3
Coax Cable
2
3
4 5
6
7
1
Using the supplied N-Male to RP-SMA-Male coax cable, connect the Shock-WAV Wi-Fi Signal
Booster to your WG103’s Antenna port . (Figure 3 )
1
. Be sure to connect the cable to the
side of the Signal Booster labeled WAP
2
. Next use the included barrel connector
4
to
connect the splitter
4
to the side of the Signal Booster labeled Antenna
3
.
Using the two N-
Male to N-Male cables
6
connect the Splitter
to the two X-WAV XW-24-FP7 antennas
7
.
WARNING!:
Do not attempt to connect or disconnect any components while the
Netgear WG103 WAP or Shock-WAV signal booster are plugged into
power. Doing so may cause equipment damage and/or physical injury
and will void your warranty.
