Luxor BTS1200, Инструкция по эксплуатации

Страница: 14 / 16

14 | ENGLISH
INSTALLATION
NOTE: Unit must be connected to a grounded socket.
CONNECTING YOUR SPEAKERS:
For proper performance the speakers must be wired correctly.
• To insure proper phasing, connect the speaker cable between
the red terminal on the master speaker to the red terminal on
the slave speaker. Then follow the same procedure for the
black terminals. The cable is marked for easy match.
PLACEMENT:
Because of the great off-axis response and excellent dispersion
of these speakers, they are less critical to position than most
loudspeakers.
• If you install your speakers outdoor, select location facing your
listening area and that is protected from rain, snow, and out of
direct sunlight.
• Start by placing the speakers directly in front of your primary
listening position. Avoid hard vertical edges within one meter
of either side of the cabinet.
• The performance of these speakers is optimized for listeners
being positioned on a distance of 3-4 meters in front of the
speaker.
NOTE: Keep the speakers indoor during winter, to avoid damage.
WALL MOUNT:
• Install the wall mounts on desired locations. Pay attention to
top and bottom of wall mount. Center dimension for the screw
holes is 158 mm.
• Connect the speaker cable between the speakers, and the
power cable to the master speaker.
• Attach the speakers to the wall mounts with the screws (adjust
angle before tightening).
NOTE:
If you install your speakers outdoor, you should mount them
in vertical position. This is to avoid water getting inside via the cable
openings, as it may cause damage to the speakers.
Top
Bottom