WARRANTY
All fiber optic transmission systems, products and accessories
manufactured by Liteway, Inc. and it’s subsidiaries are fully tested
prior to shipment and are warranted against defective materials
and workmanship for a period of five full years from the date of the
original shipment. Should a problem occur, a Return Material
Authorization Number (RMA) must be obtained from Liteway Inc.
at (516) 931-2800 and the item returned to Liteway, Inc. 166
Haverford Road, Hicksville, NY 11801, USA, prepaid. Liteway Inc.
will then, at its option repair or replace the defective item.
Liteway, Inc. maximum liability under this warranty is limited to the
cost of the defective item only. No contingent liabilities of any kind
are either assumed or implied.
Any items returned to Liteway, Inc. that have been misused,
abused, damaged, modified, connected or adjusted in any way
contrary to the instructions furnished by Liteway, Inc. or repaired
by unauthorized personnel will not be covered by this warranty.
Any non-warranty repairs required will be quoted at the current
rate for such services.
Important Notices
CAUTION !
AVOID DIRECT EXPOSURE TO BEAM.
All –5, -7, -8, and -9 Models use laser diodes. These solid-state
laser diodes are located in the optical ports of these units. Laser
diodes produce invisible radiation that may be harmful to human
eyes. Never look directly into the optical port of any fiber optic
unit designed to operate with single-mode optical fiber.
NOT FOR LIFE SUPPORT SYSTEMS
Liteway, Inc. does not authorize or warrant any of its products or
accessories for use in critical life support systems or applications
of any kind.
© Copyright 2017 Liteway, Inc.
122995 Rev D
OPERATING INSTRUCTIONS
LuxLink
®
Redundant RF Switch
Model RSW-3002
The RSW-3002 is a two input single output automatic switch
designed to implement a redundant, fail-safe RF transmission
system with any fiber optic system.
Technical Specifications
RF Switch Bandwidth
100 Hz to 1 GHz
In/Out Impedance
50 ohms
Isolation
50 dB minimum
Insertion Loss
1 dB maximum
Signal Connectors
BNC
RF Rx Bandwidth
100 Hz to 750 MHz (indicator only)
Rx In Signal Level
+13 dBm (3V peak to peak)
Rx Hysteresis
2-3 dB
Indicator Lights
Pwr, Primary, Secondary, Alarm
Power & control
connectors
Removable terminal Block
Temperature Range
-35º to +75ºC
Alarm Contact Ratings
0.5A 125 VAC 1 ampere 24 VDC
Power Requirements
11-24 VAC/DC @150 mA
Physical Size (mm)
5.0”(127)L x 1.0” (25.4)W x 3.0”(7)D
All specifications are subject to change without prior notice.
!
