Luxli Taiko, Руководство пользователя

Страница: 6 / 28

6
Setting up the Taiko
Attaching the Tilt Lock Handle
The tilt lock handle can be attached to either side of the Taiko. To attach the handle, follow these
steps:
1. Place the Taiko and yoke down on a flat surface.
2. Use the included hex key to remove one of
the tilt control screws, and replace it with the
tilt lock handle. Screw in the handle so the
threads are engaged, but don’t tighten it.
3. Use the hex key to tighten the control screw
on the other side of the yoke. Tighten it
enough until there is some resistance while
tilting the Taiko in the yoke.
4. Tighten the handle until the yoke is locked
and secure.
Note: If the yoke seems too lose when the tilt lock handle is disengaged, use the hex key to slightly
tighten the control screw opposite the handle.
Mounting the Taiko to a Light Stand
Loosen the mounting lock and place the receiver over the light stand’s 5/8” pin. Tighten the
handle until secure.
Note: If you’re unable to turn the tilt lock handle 360°, pull the handle out, reposition it, and push
it back in until it reengages.