Wireless Transmitter Setup Instructions
09/2016
Setting up
For either type transmitter, use these instructions to pair with a ZR30-AX1 lamp OR TR30-AX1 luminaire.
Setting the lamp to factory conditions:
1.
Begin with the power turned off to both the Wi-DMX transmitter and the light.
2.
Set DIP switch to 1011 1100
3.
Turn power on to the light
a.
Lamp should flash lime-green-black repeatedly
4.
Change the DIP switch to 1011 1101
a.
The lamp will rapidly flash the red color
b.
5 seconds later the red flashing will stop
c.
Change DIP switch to any other setting as desired
i.
(typically DIP setting will become the DMX address value)
Setting the Wi-DMX transmitter to pair with the lamp:
5.
Turn on the power to an unpaired lamp that needs to be paired with the transmitter
6.
With the transmitter power off, hold down the red button on the Wi-DMX transmitter
7.
Then turn on the power to the Wi-DMX transmitter
a.
Wi-DMX blue LED will blink rapidly
b.
Release the red button as soon as LED starts flashing
c.
When the blue LED changes to slow blinking the transmitter is paired with the lamp
8.
The Wi-DMX transmitter is now paired with the lamp.
9.
For situations where radio rf interference may interrupt the signal a channel change feature
is available. See the section on
“
Advice for Transitter use
”
Setting the Wi-DMX ByPhone
TM
transmitter to communicate with a mobile device over Art-Net
TM
:
10.
First step is to pair the transmitter to at least one ZR30, using instructions above
11.
Be sure the Wi-DMX ByPhone
TM
transmitter is powered on
12.
Go to the wi-fi settings on the mobile device, s
elect the SSID “widmxbyphone xxx”.
a.
The SSID name is shown on a label on the side of the Wi-DMX ByPhone
TM
.
13.
Enter the password “widm
xX
XXXX”
a.
This is a WPA/WPA2 PSK 10-character password
b.
This will connect the mobile device with the router that is inside the Wi-DMX
ByPhone transmitter.
14.
Now use your application for DMX control on your phone or table to control the lamp
a.
You will need a DMX capable application on your mobile device to communicate
with the lamp.
Unpairing a Lamp (must be done when connecting to another transmitter or switching to wired mode)
1.
Start with power off to the lamp
2.
Set DIP SW to1011 1100
3.
Turn power on to the light
a.
Lamp will flash Lime-Green-Dark in sequence.
4.
Lift the rightmost switch
a.
DIP switch setting will be 1011 1101
b.
At this time the lamp flashes red for a few seconds.
c.
Now the light is reset and is waiting to be paired with another transmitter.
