4
WSP11 Rev. B 03/2021
Luxier USA
Installation
A. Shut off water supply at the valves.
Remove old faucet and clean the mounting
surface for installation of new faucet.
D. Slide hot and cold water handle through
the 2 side mounting holes. Handles should
point outward in off position. Secure the
handles with the mounting nut.
G. Remove rubber washer and locking nut
from the drain assembly and slide the drain
into the sink. Install the rubber washer first
and tighten the locking nut to install the
drain. Connect the drain to the P trap and
waste pipe.
F. Apply Teflon (PTFE) tape on the shut off
valves. Thread the tape in counter-clockwise
direction. Use a wrench to tighten the hoses.
Please do not overtighten the connections.
E. Connect the 2 supply hoses to the Tee
connector. Make sure the hose are fully in
-
serted until locked in place. There will be an
audible click when the hoses are connected
properly.
H. Turn on water supply and
remove the
aerator with a small coin or a flat head
screwdriver and let the water run for about
1 minute to clear any debris in the plumbing
system. Check for leaks at all connections.
Reinstall the aerator to complete the
installation.
(
NOTE
: Sediments or mineral buildup will
clog the aerator and decrease water flow.
It is recommended to clean the aerator
regularly to maintain proper water flow.
B. Place spout through the center mounting
hole on the surface. Secure spout with C
shaped washer, C shaped metal washer and
locking nut.
C. Insert the Tee connector to the center
spout inlet hose until it clicks in place. Make
sure the hose is fully inserted. There will
be an audible click when the connector is
connected properly.
HOT
COLD
A
B
C
D
Rubber Washer
Locking Nut
G
water supply line
F
H
E
