LX120
V. 05 – 23/07/2014
7
©Velleman nv
IP Mode
[Only used with Art-Net]
Static
Uses the device's preset IP address
DHCP
IP address provided by router
Manual
Sets IP address manually
Net
0-127
Only used with Art-Net
Subnet
0-15
Only used with Art-Net
Universe
0-15
Only used with Art-Net
Start Channel
1-512
Only used with Art-Net
Minimum Dimmer
0-100
Sets the minimum dimmer value
9.3
Automatic mode
In automatic mode, the device runs built-in programs.
To set the device to automatic mode:
1.
Connect nothing to the DMX input of the device.
2.
Press <MENU> until <Auto Show> is displayed and press <ENTER>.
3.
Use <UP> and <DOWN> to select one of the built-in programs.
4.
Press <ENTER> to confirm.
9.4
Master/Slave Mode
The master/slave mode allows connecting several devices to a single master device. All slave devices will then
work synchronously with the master device.
You need to set one device to master mode and all other devices to slave mode.
1.
Connect all devices in series with DMX cables.
2.
The first unit in the chain functions as the master device. Set up the unit as described in the section
Automatic Mode above.
3.
On the master device, press <MENU> until <Master/Slave> is displayed and press <ENTER>.
4.
Use <UP> and <DOWN> to select <Master> and press <ENTER>.
5.
On each slave device, press <MENU> until < Master/Slave > is displayed and press <ENTER>.
6.
Use <UP> and <DOWN> to select <Slave> and press <ENTER>.
9.5
DMX Mode
This mode allows you to control the device by any universal DMX controller.
All DMX-controlled devices need a digital start address so that the correct device responds to the signals.
This digital start address is the channel number from which the device starts to “listen” to the DMX
controller. The same starting address can be used for a whole group of devices or an individual address can
be set for every device.
When all devices have the same address, all the units will “listen” to the control signal on one particular
channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you
set individual addresses, each device will “listen” to a separate channel number. Changing the settings of
one channel will only affect the device in question.
To set the device to work with a DMX controller:
1.
Press <MENU> until < DMX Channel> is displayed and press <ENTER>.
2.
Use <UP> and <DOWN> to select a channel DMX mode and press <ENTER>.
3.
Press <MENU> until < DMX Address> is displayed and press <ENTER>.
4.
Use <UP> and <DOWN> to set the DMX starting address (1–508) and press <ENTER>.
9.6
DMW Addressing
Example
To use the 1-channel mode, set the start address of the first unit to 1 (CH1), the second to 2 (CH2), the third
to 3 (CH3), and so on. The highest start address is 512.
Use the table below to define the correct address. The table shows the settings for units 1 to 3. Apply the same
principle for the other units.
Содержание LX120
Страница 1: ...LX120 LUXIPIX 7X7 LED MATRIX USER MANUAL...
