8
Installation
There are specific regulations like BGV C1 (old VBG 70) or country related regulations which
need to attend during the installation. The installation has to be handled by skilled persons
only!
Suspension device hast to be built and calculated in order to handle up to 10 times its
specific load limit over a time of one hour without permanent or harmful deformation.
Installation has to be done with a separate, independent suspension device like a safety
chain. A second suspension device has to be built in order to assure that in case of error no
part of an installation can fall off.
Trespassing the danger zone below the installation during the assembling is prohibited.
Installer has to take care of all safety and machinery installations are approved by authorized
persons before first operation or after changes before restarting.
Installer has to take care of all safety and machinery installations are approved by skilled
persons at least once a year.
Installer has to take care of all safety and machinery installations are approved by authorized
persons every four years during the acceptance inspection. Spotlight should ideally installed
outside peoples lounge area.
Attention
Installation overhead needs a high level of experience. This includes (but is not just limited
to) calculation and definition of load capacity, used installation material and regular safety
inspections of used material and the fixture itself. Never try to do the installation by yourself if
you are not qualified, instead you have to instruct a skilled installer. Inappropriate
installations can cause injuries and/or damage of property. Spotlight has to be installed
outside areas where people can touch it.
Professional truss system or similar licensed suspension systems have to be used if the
spotlight is used in suspension from ceiling or other constructions. Spotlights can never be
installed freely suspended!
Spotlights can cause injuries when fall off. If you are not trained in questions of safety for the
different kinds of installation do NOT install the spotlight! Assure that the mounting surface
can hold at least ten times the point load of the spotlight before installing the fixture.
Assure the specified safety distances to flammable material.
Attach the spotlight with its yoke and the use of a suitable hook/clamp to your truss system.
The therefor used opening has a diameter of about 12 mm. According to your installation
also similar but approved suspension devices are possible.
When installing the spotlight overhead make sure to safe the fixture by a safety chain which
is specified at least with a load limit of 12 times of the spotlights weight. Only safety chain
with approved connective can be used. Attach the safety chain to its designated opening and
attach it to the truss system or a similar and safe attachment point. Assure to close the
fasteners as specified.
To adjust the angle of the fixture open the locking screw, set the fixture in its position and
close it by hand.
Содержание B EXPO350M
Страница 1: ...1...
