LuxHome
433MHz Wire Free Remote Control
Installation and Operating Instructions
These instructions should be read in conjunction with
your System Installation and Operating Instructions
and be retained for future reference.
Introduction
The LuxHome Remote Control is designed for use
with LuxHome Wire Free Intruder Alarm systems
operating on 433MHz only.
Tr
ansmit LED
Any number of Remote Controls can be used with your
system, providing they are all coded with the same
system House Code.
The Remote Control is powered by a CR2032 type
Lithium Cell battery which under normal conditions will
have a typical life up to 1 year. Under normal battery
conditions the LED on the Remote Control will only
illuminate when a button is pressed. However, under
low battery conditions the LED will flash every time
the button is pressed. When this occurs the battery
should be replaced as soon as possible.
Arm
Part-Arm/
Delay-Arm*
Disarm
Slide up
to operate
Personal Attack
Setting the Remote Control
The Remote Control has no Tamper Protection
1. Remove the front cover by undoing the small screw on
the rear of the Remote Control.
* Part Arm with Control Unit
Systems or Delay-Arm with
Siren only systems
The Remote Control Unit is used to Arm and Disarm the
system. The Remote will activate the Instant Arm, Part-
Arm/Delay-Arm or Disarm functions dependent upon which
System it will be used with (refer to your System
Installation and Operating Manual).
The Remote Control also incorporates a Personal Attack
Switch (PAS). Activating the PAS will immediately initiate a Full
Alarm condition whether the system is Armed or Disarmed,
(unless the system is in Service, Test or Program mode).
House Code
Dip Switches
Jumper Link
Battery Clip
Battery
2. Located above the battery cover is a row of 8 DIP
switches. These switches set the House Code for the
