5
Setting the PIR Detectors
Located on the PCB of the PIR
Detector are two blocks of DIP
switches (SW and SW3). When
setting Dip Switches to House
Code, hold the PIR Detector ‘upside
down’ as shown in the diagram on
the right:
1. DIP switches SW (numbered
1-8) are used to set the House
Code for the PIR Detector and
must be set to the same ON/OFF
combination as the House Code
DIP switches in all other system
devices.
. Set the alarm zone which the PIR
Detector will operate on, with DIP
switches 1-3 of SW3 as follows:
Setting for Siren only Alarm System
For a Siren only Alarm System, DIP switches 1-3 of SW3 must be set as follows:
DIP 1
DIP 2
DIP 3
ON
ON
OFF
Setting for an Alarm System with a Control Panel
If your system has a Control Panel, DIP Switches 1-3 of SW3 should be set as
follows:
DIP 1
DIP 2
DIP 3
Zone 1
OFF
OFF
OFF
Zone 2
OFF
OFF
ON
Zone 3
OFF
ON
OFF
Zone 4
OFF
ON
ON
Zone 5
ON
OFF
OFF
Zone 6
ON
OFF
ON
