PIR Detector
Next proceed to add the PIR Detector. Locate the PIR Detector and CR123A battery supplied.
Remove the single screw at the bottom of the unit then lift and remove the back cover.
Insert the battery into the battery bay ensuring correct polarity. Once installed press and release
the tamper switch inside the PIR detector.
The PIR detector should ‘auto pair’ within 1 minute. To test the PIR detector press and hold the
tamper switch inside the PIR detector for at least 30 seconds then release. The Voice Siren
should report: Alert tamper on motion detector.
If for any reason the PIR detector does not appear to have ‘auto paired’ refresh your browser
screen. If this fails use the + Add a device method selecting PIR detector.
The Learn Button on the PIR detector is the tamper switch inside the PIR detector. Press and
hold for approximately 4 seconds then release.
Your PIR detector should be wall mounted preferably in the corner of the room using the 2 x
fixing screws and plugs provided. Alternative you can mount on a flat surface using the screws
and plugs provided or the double sided sticky pads.
Magnetic Detector
Next proceed to add the Magnetic Contact Detector. Locate the Contact Detector and CR2450
battery supplied. Press and slide the cover off of the Detector.
Insert the battery with the + sign facing you and refit the cover by sliding it on until it clicks. Then
remove the small pull slip from the back of the detector, it should ‘auto pair’ within 1 minute.
To test the detector press and hold the tamper switch inside the PIR detector for at least 30
seconds then release. The Voice Siren should report: Alert tamper on magnetic detector.
If this fails use the + Add a device method selecting Magnetic detector.
The Learn Button on the Magnetic detector is the tamper switch inside the Magnetic detector,
located to the upper right below the LED status light. Press and hold for approximately 3
seconds then release.
Your Magnetic detector should be mounted with the detector on the wall and the magnet on the
door or window with no more than 15mm between them when closed. You can screw to the wall
or door or use the provided double sided sticky pads.
This concludes the adding of the devices that auto pair to the gateway. The next step will involve
adding the IP Camera to the system, if your system does not include the IP Camera then you
can skip ahead to
Step 16
.
Содержание HomeSys
Страница 1: ......