Product Name:
Resin Angel Outdoor Patio Fountain
SKU #:
WHF718
Contact: [email protected]
Instruction Manual
Please save this manual for future reference.
CARE & MAINTENANCE:
1.
Keep the water clean – clean water will prolong the useful life of your pump.
2.
Use a pre-filter on your pump if available.
3.
Regular cleaning of the pump will be necessary depending upon the environment in which it is operated.
Clean the pump when it is visibly soiled or when a noticeable drop in performance is detected.
Failure to
clean the pump will result in overheating of the pump and the voiding of the warranty!
4.
Before cleaning, always disconnect the pump from the power source.
5.
Disassemble the pump by removing the inlet screen & the impeller housing. Remove the impeller/rotor
assembly by gently pulling on the impeller blades. Use a soft cloth or brush to clean the area inside of the
pump where the impeller/rotor assembly was. Clean the inlet screen, impeller housing & impeller in warm
soapy water. Reassemble the pump and inspect for proper operation.
TIPS AND TROUBLESHOOTING:
1.
Ensure that the pump’s flow control switch is set to maximum (+) before operating. Once the flow is
established, the pump can be adjusted downward to the desired level.
2.
If the pump operates, but there is no flow, check to ensure the pump is fully submerged.
3.
If the pump operates, but there is no flow, check the supply tubing for kinks and correct.
4.
If the pump operates, but there is no flow, and if the pump is submerged and there are no kinks in the
supply tubing, lift the pump from the water. Remove supply tubing at pump outlet and clean tubing inside
and out if necessary. Reset pump in water (outlet side up) and once water begins to flow, re
-attach the
supply tubing.
SAVE THESE INSTRUCTIONS
– This manual contains important safety and operating instructions for power units.
