Product Name:
Cement Modern Four-Tier Pedestal Outdoor Fountain with LED Light
SKU #:
WHF929
Contact: [email protected]
Instruction Manual
Please save this manual for future reference.
•
Always disconnect the pump from the power source before performing any maintenance on the pump,
lights (if equipped), or fountain.
•
Do not exceed the voltage shown on the pump.
•
Check the water level regularly to ensure the pump is completely submerged during operation. The pump
should be fully submerged during operation. Do not add water while operating the product. Always
disconnect the pump from the power source before adding water.
MAINTENANCE OF YOUR FOUNTAIN:
•
Keep water clean
-
using clean water will reduce mineral deposits and improve water clarity.
•
Clean the fountain periodically to prevent mineral deposits and contamination. Use warm soapy water and a
stiff brush for heavily stained surfaces.
Do not use harsh chemicals as this will damage the finished surface
and void the warranty.
•
Add clean water periodically to ensure that the pump is fully submersed in water.
•
Disconnect the power and empty the basin if the fountain will not be used for an extended time.
•
If installed outdoors and in a freeze-area of the country, ensure that all water is removed and the unit is
completely dry.
This product is NOT to be operated below 41
℉
(5
℃
) freeze damage may occur.
WARNINGS:
1.
To reduce the risk of electric shock, connect only to a properly grounded, grounding type receptacle.
2.
To reduce the risk of electric shock, use only on portable self-contained fountains no larger than 5 feet in
any dimension.
3.
Do not exceed the voltage shown on the pump.
4.
Always disconnect the pump from the power source prior to beginning any maintenance or work on the
pump or fountain.
5.
Inspect the power cord for damage before installation and/or maintenance. Replace the entire pump if
damage is found.
6.
For pumps with a 3-prong, grounded type plug, do not remove the grounding pin from the plug on the
power cord.
PUMP ASSEMBLY INSTRUCTIONS:
Remove the pump from the package and untie the power cord.
1.
Place the pump in the desired location in your pond or fountain ensuring that it is completely submerged in
the water. If the pump is to be used in a pond, raise the pump off of the pond floor to ensure that it is
above any dirt that will collect, as this will adversely affect the performance of the pump.
2.
Adjust t
he flow rate (if applicable) to the maximum (+) position.
3.
Connect the power cord from the pump to a properly grounded, grounding type receptacle (GFCI).
