Product Name:
43.1in. H Rain Forest Bronze Metal Leaves Cascading Fountain
SKU #:
WHF553
Contact: [email protected]
Instruction Manual
Please save this manual for future reference.
2.
Select a flat, level surface for the assembly and final location of your fountain.
3.
Place the basin on the level surface flat and insert the pump outlet into the water pipe on the underside of
fountain top. Align the cord slot of the fountain top with the wedge in the basin and place the fountain top
onto the basin. Center the fountain top over the basin guides and draw the pump power cord out through
the cord slot on the bottom edge of the fountain top. (Fig. 1)
4.
Add clean water into the basin. The water level should be approximately 25mm lower than the top edge of
the basin. (Fig. 1)
5.
Connect the pump power cord to a ground fault circuit interrupter (GFCI) outlet and the product will begin
to function as intended. (Fig. 2)
6.
To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed in an area
where it cannot be damaged.
7.
Do not leave your fountain running for extended periods of time when no one is present to observe the
performance.
8.
Check the area around your fountain on a regular basis to ensure that there is no leakage.
9.
Please refresh the fountain with water each week to ensure it in good condition.
