Product Name:
Black Resin Old Tire Frog Friends Outdoor Fountain
SKU #:
WHF1548
Instruction Manual
SAVE THESE INSTRUCTIONS
–This manual contains important
safety and operating instructions for power units.
MAINTENANCE OF YOUR PUMP:
•
Keep the water clean – clean water will prolong the useful life of your pump.
•
Use a pre-filter on your pump if available.
•
Regular cleaning of the pump will be necessary depending upon the environment in which it is operated. Clean the
pump when it is visibly soiled or when a noticeable drop in performance is detected.
Failure to clean the pump will
result in overheating of the pump and the voiding of the warranty!
•
Before cleaning, always disconnect the pump from the power source.
•
Disassemble the pump by removing the inlet screen & the impeller housing. Remove the impeller/rotor assembly by
gently pulling on the impeller blades. Use a soft cloth or brush to clean the area inside of the pump where the
impeller/rotor assembly was. Clean the inlet screen, impeller housing & impeller in warm soapy water. Reassemble
the pump and inspect for proper operation.
MAINTENANCE OF YOUR FOUNTAIN:
•
Unplug the pump from electric power before servicing, cleaning, or moving.
•
Keep water clean
-
using clean water will reduce mineral deposits and improve water clarity.
•
Clean the fountain periodically to prevent mineral deposits and contamination. Use warm soapy water and a stiff
brush for heavily stained surfaces.
Do not use harsh chemicals as this will damage the finished surface and
void the warranty.
•
Add clean water periodically to ensure that the pump is fully submersed in water.
•
Disconnect the power and empty the basin if the fountain will not be used for an extended time.
•
If installed outdoors and in a freeze-area of the country, ensure that all water is removed and the unit is completely
dry.
This product is NOT to be operated below 41
℉
(5
℃
) freeze damage may occur.
Special Warnings and Cautions:
CAUTION:
•
The pump has been evaluated for use with water only.
•
Do not use the pump in water exceeding 35ºC / 95ºF.
•
Do not use the pump in flammable liquids.
•
Do not use the pump for industrial purposes.
•
Do not use the pump in vehicles or on ships or aircraft or swimming pools.
•
Do not use the pump in location where special conditions prevail, such as the presence of a corrosive or explosive
atmosphere (dust, vapor or gas).
•
Do not let the pump run dry. Pump must be completely submerged for proper operation and cooling.
•
Do not lift the pump by its power cord.
•
Keep the plug dry. Do not expose the plug to water or steam.
•
Before connecting to the power source, make sure that the pump is assembled and completely submerged in water.
•
Check the water level regularly to ensure the pump is completely submerged during operation. The pump should be
fully submerged during operation. Do not add water while operating the product. Always disconnect the pump from the
power source before adding water.
