Instructions
12
!
Avoid drastic changes in the duct cross-section.
!
Use a duct with an as smooth as possible inside.
!
The duct must be made of certified material.
Filter version
(draw. 22, 23, 24)
One active charcoal filter is needed for this and can be obtained from
your usual retailer.
The filter removes the grease and smells from the extracted air before
sending it back into the room through the upper outlet grid.
Installation
The minimum distance between the supporting surface for the cook-
ing equipment on the hob and the lowest part of the range hood must
be not less than
5
cm from electric cookers and
5
cm from gas or
mixed cookers.
If the instructions for installation for the gas hob specify a greater
distance, this must be adhered to.
Electrical connection
The mains power supply must correspond to the rating indicated on
the plate situated inside the hood. If provided with a plug connect
the hood to a socket in compliance with current regulations and
positioned in an accessible area, after installation. If it not fitted with
a plug (direct mains connection) or if the plug is not located in an
accessible area, after installation, apply a double pole switch in ac-
cordance with standards which assures the complete disconnection
of the mains under conditions relating to over-current category III, in
accordance with installation instructions.
Warning! Before re-connecting the hood circuit to the mains supply
and checking the efficient function, always check that the mains cable
is correctly assembled.
The hood is provided with a special power cable ; if the cable is dam-
aged, request a new one from Technical Service.
