Lux Tools 401 122, Оригинальное руководство пользователя

Страница: 27 / 96

27
• Ensure that children are not able to play
with the device.
• Always comply with all applicable
domestic and international safety, health,
and working regulations.
Electrical safety
• The device may only be connected to a
socket that is correctly installed and
grounded.
• The fuse must be a residual current cir-
cuit-breaker with a measured residual
current of no more than 30 mA.
• Make sure that the power supply corre-
sponds with the connection specifica-
tions of the device before it is connected.
• The tool may only be used within the
specified limitations for voltage and
power (see type plate).
• Do not touch the mains plug with wet
hands! Always pull out the mains plug at
the plug and not by the cable.
• Do not bend, crush, pull or drive over the
power cable, protect from sharp edges,
oil and heat.
• Do not lift the device using the cable or
use the cable for purposes other than
intended.
• Check the plug and cable before each
use.
• If the power cable is damaged immedi-
ately disconnect the plug. Never use the
device if the power cable is damaged.
• If the device is not in use make sure the
plug is pulled out.
• Make sure that the device is switched off
before plugging in the mains cable.
• Make sure that the device is switched off
before unplugging it.
• Disconnect the power supply before
transporting the device.
Maintenance
• Before conducting any maintenance on
the device, disconnect the mains plug.
• Only those maintenance and fault elimi-
nation tasks described here may be car-
ried out. Any other tasks must be com-
pleted by a specialist.
• Only use original replacement parts. Only
these replacement parts are designed
and suitable for the device. Other
replacement parts will not only lead to an
invalidation of the warranty, they may
also endanger you and your environment.
Device-specific safety instructions
• Do not reach into the hopper or the verti-
cal chute while the device is operating.
The device runs for approx. 5 seconds
after it has been switched off.
• Before switching on, the device must be
assembled according to regulations.
• Before switching on, check whether all
screws, nuts and other fastening ele-
ments are tight and all protective equip-
ment is attached properly.
• When working with the device, always
maintain a safe distance and natural body
position.
• Only work in good light and vision condi-
tions.
• The operator must wear tightly fitting
clothing. Avoid wearing loose clothing.
Wear sturdy shoes and long trousers.
• Only use the machine outdoors and on a
firm, even surface.
• When working, leave sufficient space
around the device. Do not set the device
too close to walls.
• Do not lift, tip or transport the device
when it is operating.
• Make certain before starting the device
that the hopper is empty.
• Do not leave a switched-on device unsu-
pervised.
• During operation, make sure that no for-
eign bodies (such as stones, glass, metal,
soil, plastic, etc.) penetrate the device.
The blades can be dulled and the motor
damaged.
• If foreign bodies penetrate the cutting
tool, the device makes unusual noises or
vibrates in an unusual fashion, switch the
motor off immediately and let the
machine run out.
• Check before switching on that the
blades are mounted properly and that
they are tight.
• Never use the device without the feeding
hopper.
• If the chipper is stopped up, first switch
the device off, disconnect the mains plug
from the outlet and wait until the device
stops completely before removing the
stoppage. Keep on/off switches clean
and free of foreign bodies.
GB
Haecksler_401122.book Seite 27 Donnerstag, 7. April 2016 8:40 08