Lutz-Jesco EASYPURE 1000, Руководство по эксплуатации

Страница: 24 / 34

Shutdown
Short-term shutdown
24
© Lutz-Jesco GmbH 2015 BA-70200-02-V01
Polymer preparing and dosing station EASYPURE Powder and Liquid Operating instructions
9 Shutdown
9.1 Short-term shutdown
Perform the following working steps:
1.
Press F4 for OFF .
4
Automatic operation is stopped.
2.
Set the main switch on the control cabinet to OFF .
ü
System shut down for the short term.
9.2 Long-term shutdown
Perform the following working steps:
1.
Press F4 for
OFF
.
4
Automatic operation is stopped.
2.
Set the main switch on the control cabinet to
OFF
.
3.
Disconnect the system from the voltage supply and secure against
reactivation.
4.
Empty the dry feeder and the dry feed supply hopper.
5.
Connect the shut-off valve to the dosing chamber output.
6.
Open the shut-off valves of the preparation chamber and the
maturing chamber as well as the overflow shut-off valve.
7.
Empty the system completely.
8.
Rinse the system chambers.
9.
Then close the overflow shut-off valve.
10.
Disconnect the dosing line from the dosing pump and empty the line.
11.
Rinse the dosing pump.
12.
Disconnect the water supply.
ü
System shut down for the long term.
9.3 Storage
Required actions:
ü
The device has been shut down in accordance with the section 11.2
“Long-term shutdown”.
Storing the device correctly will extend its service life. You should avoid
negative influences such as extreme temperatures, high humidity, dust,
chemicals, etc.
Ensure ideal storage conditions where possible:
n
the storage place must be cold, dry, dust-free and generously
ventilated,
n
temperatures b 0 °C and + 50 °C,
n
Relative air humidity must not exceed 90 %.
9.4 Transportation
Required actions:
ü
The device has been shut down in accordance with the section 11.2
“Long-term shutdown”.
n
The device may only be transported when empty and using suitable
lifting and transport equipment.
n
Avoid heavy blows at all costs.
n
The device can be transported using carrying straps fixed to the
central side edges of the three chamber tank. Ensure that the load is
distributed evenly and components do not become jammed.
n
The danger of cold embrittlement of the plastics which it contains
means that the device may not be transported at temperatures under
0° C. Cracks in welded seams, container walls and reinforcement
frames could result.
If the device is sent back to the manufacturer, please follow sections 16
„Declaration of no objection“ on page 30 and section 17 „Warranty
claim“ on page 31.
9.5 Disposal of old equipment
n
The device must be disposed of in accordance with applicable local
laws and regulations. It should not be disposed of as domestic waste!
n
As the disposal regulations may differ from country to country, please
consult your supplier if necessary.
n
In Germany, the manufacturer must provide free-of-charge disposal,
provided the device has been safely returned along with a declaration
of no objection (see page 30).