Optional Wall Mounting
The Repeater can be wall mounted using the supplied wall
bracket.
Attach wall bracket to wall using
the supplied screws and wall
anchors.
Wrap excess power supply cord
around the cord holder. Align
Repeater and snap onto wall
bracket.
UP
UP
RF Signal Repeater
Installation
Check off Steps as completed.
Step 1
Find a suitable location for the RF Signal Repeater.
Choose a discreet location that is centrally located to all
system controls. The Repeater must be located within 30
feet (9m) of all system controls or within 60 feet (18m) of
a previously installed Repeater.
Step 2
Attach the power supply cord to the Repeater (jack
located on rear of Repeater).
Step 3
Plug the other end of the power supply into a
120/127VAC, 50/60Hz wall receptacle.
MAIN
MODE
INSTALL
ADDRESS
SET UP
BEEP
FLASH
TESTING
AUXILIARY
System Layout
Each RF Signal Repeater will cover approximately a 2000 square foot
area.
This diagram shows a 3000 square foot home requiring two RF Signal
Repeaters.
All system controls must be within a 30 foot (9m) distance, in any
direction, of an RF Signal Repeater. Each repeater must be within 60
feet (18m) of another Repeater.
MAIN
REMOTE
REPEATER MODE
INSTALL
ADDRESS
SET UP
BEEP
FLASH
TESTING
30 ft. (9M)
Repeater
50 ft.
(15m)
30 ft. (9m
All system components
MUST be within this area.
MAIN
REMOTE
REPEATER MODE
INSTALL
ADDRESS
SET UP
BEEP
FLASH
TESTING
MAIN
REMOTE
REPEATER MODE
INSTALL
ADDRESS
SET UP
BEEP
FLASH
TESTING
60 ft. (18m)
maximum
All system controls
MUST be within this area.
30 ft. (9m)
Note:
The Repeater's range is 30 feet in all directions.
MAIN
REMOTE
REPEATER MODE
INSTALL
ADDRESS
SET UP
BEEP
FLASH
TESTING
Multiple Repeaters
100 ft
(30m)
30 ft. (9m)
MAIN
REMOTE
REPEATER MODE
INSTALL
ADDRESS
SET UP
BEEP
FLASH
TESTING
