Application Note #461
2
www.lutron.com
Custom Settings
Select your preferred settings from the instructions on the following pages before proceeding; default settings are
shown in
bold
.
Note
: User is required to remove the wallplate in order to gain access to the Auxiliary button.
Timeout
•
Timeout
is the delay until light turns off after a room is vacated.
•
Test Mode
is a temporary, short timeout (less than 15-seconds) that can be used to test the sensor’s coverage. After
entering test mode, the device will exit test mode automatically after 5 minutes, or when any button is pressed. If no
motion is detected for more than 15 seconds, the light will turn off. If motion is detected, the light will turn on and
continue to stay on for as long as motion is detected. The lens will flash periodically, indicating that motion has been
detected.
Model Numbers
MS-OPS2 MS-VPS2
MS-OPS5M MS-VPS5M
Number
of flashes
1
Test mode
2
1 minute
3
5 minutes
4
15 minutes
5
30 minutes
Example 1a: Changing the Timeout to 15 minutes
1. Press and hold the On/Off button.
2. Release the button after the lens flashes for the
fourth
time.
Model Numbers
MS-OPS6M2-DV MS-VPS6M2-DV
MS-OPS6M2N-DV MS-VPS6M2N-DV
Number
of flashes
1
Test mode
2
1 minute
3
5 minutes
4
15 minutes
5
30 minutes
Example 1b: Changing the Timeout to 30 minutes
1. Press and hold the On/Off button.
2. Release the button after the lens flashes for the
fifth
time.