LushOne Synth, Инструкции по сборке, Страница: 15 / 21

Connectors
• The DIN connector and the 3.5mm jack socket are
mounted from the back
•
DIN connector mounts easily on the “P405” label
•
3.5mm jack socket is a surface ‐ mount part!
–
Don’t panic! It’s huge and easy to handle
–
Fits on “P206” pads
–
Put solder blob on one pad
– Melt solder and push socket in to place using locating
holes as a guide
•
Make sure the input is facing the edge of the board
– Check socket is sitting nicely
– Solder up the other pads
•
The 6 pin “ISCP” (sorry about the typo – should be
ICSP) header is mounted from the front
–
Solder in where indicated
–
If you don’t plan to change the firmware you can omit this
part
Surface mount
pads for jack
socket
Jack socket
tacked in place
with one pad