Lupus LE 180, Руководство пользователя, Страница: 88 / 114

38
5 Safely Remove SD Card
：
Indicate it is safe to remove the SD card.
Remove
：
After confirming “Save motion to AVI files on the SD card”
function has been disabled. Click [Remove] button and wait for the
message “SD Card not installed” to appear. Then, withdraw the SD card
from the IP camera site. Thus, prevents data-damage during SD card hot
swap process.
Install
：
Clicking [Remove] button without withdrawing the SD card
from the SD card slot. Enables you to click [Install] button to use the SD
card again.
6 Format SD Card
：
Click [FORMAT] button to format SD card. All recorded data in the
SD card will be deleted. After format, two files “AlarmPicture and AlarmVideo” will be
created and motion-event data will be stored in these two files.
NOTE
：
When “Save motion to AVI files on the SD card” function is enabled,
“Format SD Card” function is disabled.
NOTE: When the IP Cam terminal passes a message through to the AP terminal due
to full SD Card storage capacity. A message “SD CARD IS FULL” (red green
message flashing, per 3 seconds) will be displayed on the bottom left hand corner of
the screen, it is to remind the user that the system is under Zoom In or Frame Size
mode. These changes will later return to original status. If SMTP receiver e-mail has
been setup, then when SD Card is full the user will receive an e-mail titled “SD Card
is Full Message From IP-CAM: [hostname]”. Now user must clear the SD Card space
so that the message “SD CARD IS FULL” may disappear.