Lupus Electronics LUPUSEC XT, Руководство пользователя

Страница: 7 / 9

o
Attempted to switch to home mode while the alarm panel is in arm
mode
o
Forced activation of arm mode while alarm panel or sensors report an
error

Error LED:
LED flashes orange: system error, e.g.:
o
No SIM card
o
GSM not ready
o
Open tampering contact
o
Power failure
o
Sensor is out of range
o
Sensor is open
o
Battery of a sensor is low

Battery :
The keypad requires a 1/2AA 3V 850mAH lithium battery. The average battery
life is two years.
If the battery is low, the orange status LED flashes
Connecting the XT keypad and putting it into operation
Installation of the keypad:
1.
Remove the front cover of the keypad by unscrewing the screw at the
bottom.
2.
At the back cover you find two cavities. They are intended to be pierced –
thus, you can mark the locations for required drill holes for a wall
installation.
3.
Use screws to install the keypad on a wall.
4.
Attach the front cover again.
Connecting the keypad to the alarm panel:
1.
Enter the installation mode of the keypad by entering the installation-PIN
(default: 0000) and pressing the * button. The power LED will light up
orange.
2.
Open the main menu of the alarm panel.
3.
Open the menu “Sensors”  “Add.”
4.
Click “Start.”
5.
Press * and then 7 on the keypad. The keypad emits a signal and will be
listed in the alarm panel.
a.
If you do not hear a signal, the alarm panel did not receive the
connection request of the keypad.
b.
If the connection request was received by the alarm panel, you will
hear three short signal sounds.
6.
Add the keypad to the alarm panel by pressing “Add” next to the keypad in
the menu “Sensors”
 “Add.”
7.
Start the range test in the menu “Sensors”  “Range” and take the keypad
to the intended place of installation.
8.
Press * and then 7 on the keypad.
9.
Check the signal strength in the “Range” menu of the alarm panel (1-9).