22 Blika R
After connecting the lamp to the battery, the software runs a selftest. The lamp itself as well as the
red and blue LEDs in the switch light up once. The
battery voltage
is indicated by the blue and red
LEDs, as follows:
The blue LED fl ashes once for each volt; and then
the red LED fl ashes once for each 1/10 of a volt.
Example:
The LED fl ashes seven times blue
and fi ve times red = battery voltage is 7.5 V.
Initialization & voltage display:
more than 8.0 V
battery is fully charged
7.1 to 7.8 V
battery needs charging
6.5 to 7 V
battery is not ready for use
Interpreting the voltage display:
Operation
Each quick push of the button switches through the dim levels.
Switching:
Turn off :
To turn off the lamp, keep the button pressed.
English
23
Blika R
Meaning of LED colors
Lamp is on high beam.
Lamp is on a lower beam.
1. Battery Warning, low capacity remaining.
The red LED is lighting.
You can adjust the timing of the battery warning,
see progamming on next page.
2. Battery Warning, very low capacity remaining.
The red LED is fl ashing and Blika fl ashing ones, too.
Warning!
The red and blue LED fl ashing in turn, the lamp fl ashes 30
times.
Stop immediately! The light will be switched off .
After switching the light on again, reserve power at a low beam
is available.
When reserve power is completely discharged, the
light will be switched off automatically. So slow down!
Note:
The burn time remaining after the red LED is illuminated
depends on the total battery capacity, the ambient tempera-
ture and the age of the battery.
blue LED lighting:
green LED lighting:
red LED lighting:
red LED fl
light fl ashing ones:
blue + red LED
fl ashing in turn +
light fl ashing 5 times:
blue + red LED
fl ashing in turn:
The switch on the lamphead as well as the Bluetooth remote are equipped with a
RGB-LED to show informations about the dim level and the remaining battery
capacity.
Control concept:
Operation via the buttons of the lamphead: (Switch on by short push)
Top button: Operation of the main programs (see page 9)
Lower button: Operation of the special LEDs (Redlight, Greenlight, Spotlight, Diff uselight)
Note: An almost free assignment of the buttons is only possible through the app.
Control via the remote control:
Two operating concepts are available.
1. Operation of the lamp analogous the buttons of the lamphead
Blue button on remote = Top button of lamphead
Green button on remote = Lower button of lamphead
2.
Blue
to increase the output,
Green
to lower the output
Switching between operating concepts 1 and 2:
Press and hold the green pushbutton of the
remote control until the blue and green LEDs fl ash alternately, then let the button go.