Page | 53
NOTE
: Switch the camera to "SETUP" and after a few seconds, the camera will display "
GSM
update success
".
Testing the GSM network using “manually send mode”:
1.
Switch camera to "SET UP"
2.
After the camera boots up into Live Preview, it will search for the GSM network if a SIM
card is inserted and the GSM module is NOT turned Off in "Send Mode". The user will see
"Searching network....." on the screen. Once the camera is connected to the network, the
ISP (Internet service provider) name will show on the bottom right corner of the screen. If
the connection fails, it will show "Login fail". Press the "Right" key to search for network
again.
Note: continuously Login fail generally means the network signal is poor or the SIM card does not
have data plan in it.
3.
While in Live Preview, press 'Down' arrow to switch to Playback mode, choose a picture
using the "Right" or "Left" arrows and press OK. The camera will send the selected picture
to the preset phone number(s) and email addresse(s). After sending successfully, the LCD
screen will show ‘Send over’. If reception is poor or network is busy, it will show ‘Send Fail’.
Sending a picture takes 20s-60s depending on the network signal strength.
Using camera only to setup GSM network
1.
Select GSM SETUP from Main Menu
2.
Set SEND MODE: Off, Instant, Customized, or Daily Report
3.
Set SEND VIA: MMS or GPRS
4.
Set SEND TO: Phone, Email, or Both
5.
Set NETWORK SETUP:
NOTE
: Push the OK button to select each letter/number. The disk icon is for saving settings;
the large left arrow button is for deleting, and the small right arrow is to return to previous
menu.
a.
Phone: enter phone number using arrows
b.
Email: enter email address using arrows
c.
Cellular Provider: select your provider from the menu. If your provider is not
present, you will need to use the ‘Download Tool’ explained previously.
6.
Set PHOTO QUALITY: Normal or High
