Luna LB40, Руководство пользователя

Страница: 4 / 149

4
Issue 1 Original Version March 2016
16. Use the right tool;
• Do not force small tools to do the job of a heavy duty tool.
17. When using the drill, always ensure a safe operating distance from any swarf and do not reach into the cutting
area, or near the cutter, when the machine is running.
18. Do not overreach! Keep proper footing and balance at all times.
19. Cutting tools may shatter, ALWAYS position the guard over the cutter before activating the machine.
Failure to do so may result in personal injury.
20. Apply light pressure when commencing to cut a hole until the cutter is introduced into the work surface.
Pressure can then be increased sufficiently to load the motor. Excessive pressure is undesirable; it does
not increase the speed.
21. Use Personal Protective Equipment (PPE) when using this machine;
• Use safety glasses to prevent debris from damaging eyes.
• Use ear defenders or ear plugs for hearing protection.
• Use face or dust masks if cutting operations create dust.
• Use protective gloves to prevent swarf or debris cutting the skin.
22. Dress properly;
• Do not wear loose clothing or jewellery; they can be caught in moving parts.
• Non-skid footwear is recommended when working outdoors.
• Wear a protective hair covering to contain long hair.
This will reduce the risk of entanglement.
23. Maintain tools with care;
• Keep cutting tools sharp and clean for better and safer performance.
• Regularly check the machine for any wear or damage.
• Ensure the machine is clean and free from debris prior to use.
• Remove from the mains prior to any maintenance.
• Follow instructions for lubricating and changing accessories.
24. On completion of the cut, a slug will be ejected. DO NOT operate the machine if the slug has not ejected as it
may cause injury.
25. If the slug sticks in the cutter, move the machine to a flat surface, switch on the magnet and gently bring the
cutter down to make contact with the surface. This will usually straighten a cocked slug and allow it to eject
normally.
26. Store idle tools when not in use. All tools should be stored in a dry locked-up place, out of reach of children
27. WARNING! The vibration emissions during actual use can differ from the declared total value depending on the
ways in which the tool is being used.
28. Stay alert! Watch what you are doing, use common sense and do not operate the tool when you are tired.
DO NOT operate the machine when under the influence of alcohol or ANY illegal substances.
29. Warning! The use of any accessory or attachment, other than ones recommended in this instruction manual,
may present a risk of personal injury.
30. Insecure anchorage, a loosely fitting slide or a worn bearing in the arbor support usually causes cutter
breakage.
31. Guard against electric shock: Avoid body contact with earthed or ground surfaces (e.g. pipes, radiators,
cookers and refrigerators).
32. Electric safety can be further improved by using a high-sensitivity (30 m A/0.1s) residual current device (RCD).
33. Do not abuse the cord; never pull the cord to disconnect it from the socket. Keep the cord away from heat, oil
and sharp edges.
34. Inspect tool cords periodically and if damaged have it repaired by an authorized LUNA service facility.
35. Only use extension cables approved for site conditions.
UK