13
Operation
Adjusting the length of the stand
1. Lay the workpiece on top of the power tool's saw
table.
2. Undo the locking knobs (C), refer to the picture
under point 5 of Assembling the saw stand and pull out
the extension to the desired length.
3. Tighten the locking knobs, but do not overtighten.
4. If necessary, the table extension support legs can
be folded down by pressing in the release catches.
Adjust the length of the legs using the ball catches
in the middle of the legs. Make sure that the catches
lock properly before applying any load. The extension
support legs can be folded up again by pressing in the
ball catches.
Adjusting the roller supports
1. Undo the locking knobs (8) and move the roller
supports (A) to the desired position. Refer to the picture
under point 5 of Assembling the saw stand.
2. Tighten the locking knobs, but do not overtighten.
3. When sawing workpieces to equal lengths, fold up
the worlk stop on one of the roller supports and adjust
the distance to the saw blade.