LUMINAIRE BODY
WALL MOUNTING BRACKET
SET SCREW
PROVIDED
TO THE WALL
PLASTIC ANCHOR
NYLON WASHER
#12 X 1
screw
INSIDE
OUTSIDE
ZARA D
DIRECTION
CABLE
CABLE
OUTSIDE
INSIDE
CABLE
ZARA UDL
DIRECTION
CABLE
SILVER
COATING
BLACK
SILKSCREEN
GROMMET
FILL WITH
SILICON SEALANT
HEAT SHRINK TUBE
GROMMET
HEAT
SET SCREW
PROVIDED
CONCRETE
WALL
LUMINAIRE BODY
!
we brighten up your life
LUMZ PTE LTD
INSTALLATION MANUAL
Factory:
No.14, Jalan Anggerik Mokara 31/44, Kota Kemuning Seksyen 31,
40460 Shah Alam, Selangor, Malaysia.
Tel: (00603) 5121 1887
Fax: (00603) 5121 5187
Email: [email protected]
PIERCING THE GROMMET
Singapore Office (HQ Sales & Marketing):
1 Coleman Street #10-06, The Adelphi,
179803, Singapore.
Tel: (0065) 9758 2771
www.lumzlighting.com
ZARA/INSTALLATION MANUAL/REV.0
2/2
INSTALLATION
ZARA.UDL
ZARA
ADDITIONAL INSTRUCTIONS
PRODUCT APPEARANCE
Connect wires with connector.
# Make sure power is disconnected
before installation
Fix luminaire back to wall
mounting bracket with set
screws provided.
Make sure all screws fix tightly.
# Recommended screw: #12 X 1 screw
Pierce the rubber
grommet
Lead power supply
cables through the
hole of the grommet.
Using Hex Key provided,
remove all four set screws from luminaire
body to separate wall mounting bracket
for installation.
Pierce the grommet using power
supply cable.
Grommet for this luminaire is
suitable for cables with size
from
Ø5 mm to Ø10 mm
.
# Do not use tools or any sharp object to pierce the
grommet.
A damaged grommet may lose its waterprofing ability.
Use a heat shrink tube to wrap the cable
Apply a thin layer of silicone sealant on the cables
Slide a piece of heat shrink tube over the cables. Place it approximately
on the area that will be covered by the grommet.
Using a heat gun, heat the surface while moving the heat gun back and
forth and rotate the cables simultaneously. Put an appropriate distance
between the heat gun and the heat shrink tube to allow it to shrink.
Alternatively, a lighter can also be used to heat it.
Make sure the heat shrink tube is uniformly shrunken.
Fill the grommet cavity with
silicone sealant
The cavity on the inside of the
grommet needs to be filled with a
waterproof material in order to
prevent water from going through
the pierced hole.
The recommended way to do this is
by filling silicone sealant.
For electrical cable without jacket, electrical connection can be done in 2 ways:
