* Turn the rotating nozzle brush down; it can be used as the upholstery nozzle (for curtains and upholstery).
* Turn the rotating nozzle the opposite side; it can be used as the crevice nozzle (for awkward places, behind radiator; or for hard surfaces, pelmets, delicate objects
etc).
4. Pull out the power cord and plug it into the mains supply.
* To rewind the cable, push the cable rewind button.
Note
: When using the cable rewind, always hold the plug as the cable will rewind quickly.
OPERATION
Before starting unwind the cord to sufficient length and insert the plug into the power supply. The yellow mark on the cord shows optimal cord length. Do not unwind
the cord beyond the red mark.
Press On/Off button to switch the unit on.
* To prevent motor overheating do not work continuously longer than 30 minutes and obligatory stop vacuum cleaner for no less than 15 min.
Note
: Never use the device to vacuum clay, cement or plaster. These materials will block the filter.
You can adjust the airflow by sliding the airflow regulator on the hose handle up or down. Close it for maximum suction, open it for reduced suction.
* It is recommended that the airflow regulator
on the handle be open when cleaning curtains etc. in order to avoid them from being drawn into the device.
After vacuuming:
1. Turn off the unit by pressing the ON/OFF switch. Remove the plug from the wall socket. Press the cable rewind button with the foot until the cable has rewound
completely onto the cable drum, which is inside of the vacuum cleaner.
2.
Attach the tube for storage by one of the ways shown in the pictures:
4