www.Lumishore.com
Lumishore UK Unit 2, Technium 1, Kings Road, Swansea, SA1 8PH, UK | +44(0)208 144 1694 | [email protected]
Lumishore USA 7137 24TH Court East Sarasota, Florida 34243 | (941) 405-3302 | [email protected]
Modes of Operation
6
How to Add 3rd party 1-10V for dimming control
1 to 10 V DC Dimmer Module
Suitable for LED Driver
How to connect a STROBE FUNCTION
The lights can be strobed using a 12V Switching Signal Generator. When the signal generator is switched ON the lights will come
ON, when the signal is switched OFF, the lights will switch OFF.
Remove the strobe input cable from the switch assembly and connect to a 12Volt Strobe / signal generator. Note when strobe
function is not in use the strobe input should be kept to +12volts
12 V DC
Signal Generator
Note: In this mode, when the lights are initially switched ON they will light up and wait for a signal. Once they receive this signal they will respond (NO signal =
OFF, Signal = ON). This will remain the case until the lights are switched off and on again using the switch.
1 - 10v
Dimming
Input
The Lights can be dimmed using a 3rd party 1-10volt dimming module. Connect the 1-10volts between the green and yellow wires
of the Switch assembly. Note: The dimming module must be a Current Sink Module with a capacity >10mA
per light
- do not use a
current source module or adjustable power supply!
Battery
or PSU
+12v
Battery
or PSU
GND
NB: If Strobe Input is Not used
Strobe Input Cable Must also be connected to
BLK
GRN
YEL
RED
+V
+12V
-V
BLU
WHT
RED
12V Strobe
input
Battery
or PSU
+12v
Battery
or PSU
GND
NB: Remove Strobe Input from Switch Assembly
BLK
GRN
YEL
RED
+V
-V
BLU
WHT
RED
1 - 10v
Dimming
Input
12V Strobe
input
