Wiring.
Provide 12 volts DC to ter12V DC and GND as shown. Supply current is a
maximum of 17m/a.
Tamper.
Connect to the N/C tamper terminals as shown
Contact A
is volt free, can be set to NO or NC and will activate for 1 second on
detection. Switch capacity max 1 amp 24 volts
Contact B
is also volt free and can be set to N/O or N/C and activate for 1 second on
detection.
In addition, contact B activation time can be adjusted up to 5 minutes and it can if
required be gated with the light sensor so that it will only operate between dusk and
dawn.
Switch capacity max 1 amp 24 volts.
Warning.
Do not apply mains voltage to any part of this product.
The functionality of contact B is meant only to serve independent equipment that is
designed to switch mains lighting such as a power relay in accordance with IEE
regulations. Always consult a qualified electrician.
GX30
-
Globe
Hard Wired PIR Detector Installation Handbook
Page 4
Contact
A
Contact
B
12 volts DC
Rear view
Cut the
grommets to
allow a
waterproof
cable entry.
Front and rear tamper
