luminii Teava Suspension TEA-S Series, Инструкция по установке

Страница: 1 / 3

Page 1 of 3
Teava Suspension - Installation Instructions
REV0.1
Please read all instructions prior to installation and keep for future reference!
1. Product to be installed by a qualied electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
3. More than one person is recommended for this installation.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
Model: TEA-XX-S
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
Note:
Prior to installation all 24VDC wires must be present in
junction box. Refer to the power supply installation
instruction for additional information.
Note:
More than one person is recommended for this
installation.
standoff
location
marks
anchor
1
1.1 Align one standoff hub to the junction box & measure the
distance from standoff hub to the other hub. Then mark this
location to the ceiling, if over 72” an additional support will be
included that would also need a mark. Also marks will be
necessary if using more than one fixture. Use canopy detail to
slighting off center standoff hub.
If connecting multiple fixtures
together reference step 7.
2.1 On the marked location(s), make a hole using a 13/64" drill
bit.
2.2 Insert the anchor into the hole and push completely in.
2.3 Insert wood screw through cap & washer and then tighten to
secure into the anchors.
ceiling
drill
13/64"
drill bit
2.1
2.3
2.3
canopy detail
4-3/8"
4-3/8"
7/8"
standoff
cap
hole
2.2
2
wood screw
cap
spacer
3
3.1 While one person is holding the fixture, the other person can
slide the coaxial cable end through the clear o-rings, thumb
nut, backplate & crossbar assembly.
3.2 Peel back the coaxial cable to expose the power wires. Connect
the red (24VDC+) & black (24VDC-) power supply wires to the
fixture red & black wires.
junction box
backplate
crossbar
assembly
fixture
power wire
3.1
Note:
Prior to wiring the desired fixture height must be
determined to cut off any un-necessary wire.
4.1 Insert the wire nut connections into the junction box & align the
crossbar to the junction box holes and secure using the provided
two #8-32 screw.
4.2 Slide the backplate up to the crossbar and secure by hand
tightening the thumb nut into the crossbar.
#8-32 screw
crossbar
backplate
junction box
4.1
4
4.2
thumb nut
24V DC+ 24V DC-
3.2
strain
relief
coaxial
cable
3.1
o-ring
1.1
E472444
1.1
measure
standoff
hub
fixture
over 72”, comes
with support
support