*LAMINA RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
KM, KS, KXL & KL Channel -
Installation Instructions
Please read all instructions prior to installation and keep for future reference!
1. Product to be installed by a qualied electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
Models KMC-XX, KSC-XX, KXLC-XX, & KLC-XX
7.1
Insert the lens edge into the inside of the extrusion followed by
simultaneously rotating & pushing the lens completely inside the extrusion.
7.2
Remove the protective film from the diffuser lens.
5
5.1
Extrusion are not waterproof. If it is going to be installed
Optional:
facing up and in a wet location, drainage holes should be drilled
along the inner corner of the channel every 12". Drill 1/16" to 1/8"
diameters holes before installing LED strip.
12.00"
corner drainage hole
corner
drainage
hole
5.1
solder pads
4.1
LineLED can be shortened by cutting along the dashed lines in between
the solder pads. Make sure the cut is made on the side of the LineLED
without the wire leads. LineLED cannot touch the metal endcap which will
shorten the circuit.
cut
LineLED
cut
4.1
wire leads
LineLED
4
3.1
channel
6
6.1
Prior to installing LineLED to channel, clean channel from any debris.
Gently push LineLED onto aluminum channel and then install endcaps at
both ends.
endcap
feed LineLED wire leads
through the endcap opening
remove paper backing on the
adhesive tape of the LineLED
before installing to the channel
9.1
Ensure the correct (wattage & voltage) power supply is used to power
LineLED. Then proceed to connect LineLED wires from channel to power
supply. For more information please refer to power supply and LineLED
wiring instructions.
9
line voltage wires
low voltage wires
class II power
supply
LineLED of
channel
9.1
6.1
REV0.4 02192020
8.1
add silicone to the endcaps &
If channel is going to be installed outside,
the full length of the lens. To help avoid getting water inside the channel,
but will not make waterproof.
8
endcap
8.1
8.1
silicone
dispenser
Note:
Reference step 8 first if installing outdoors. Then return
back to this step to install lens properly.
7.1
lens
extrusion
7
protective film
7.2
Page 2 of 2
