REV1.0 June 19, 2020 2:47 PM
KILO Channel
- Installation Instructions
Page 1 of 3
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
7777 N. Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
Please read complete instruction prior to installation and keep for future reference!
1. Product should be installed by a qualified electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
3. If extrusion is installed facing up and in a wet location, ensure proper drainage and silicone endcaps and diffuser lens.
1
2
extrusion
1.1
1.1
Snap the lens into the extrusion, then align & center the extrusion to the
determined location. Make any reference marks to install the extrusion.
2.1
If necessary, extrusion and lens can be cut in the field. Using the proper
blade for aluminum cut the extrusion to the desired length. Then cut the lens
using utility shears leaving an extra 0.08” to overlap the onto the endcaps.
Note:
Prior to install, 24VDC power must be present for wiring. Also review
and account for all parts necessary to install properly.
Caution:
Safety equipment is recommended, when modifications are being
made to the extrusion & lens.
lens
reference mark
measur
e
measur
e
2.1
miter saw
extrusion with lens
extrusion
lens
3
If joining multiple extrusions.
Insert the KILO Joiner (sold separately) half way into one of the extrusion ends & tighten using the proper allen wrench. Followed
by pushing one of the KILO extrusion next to the other KILO extrusion and tighten the set screws. Repeat step for any additional connections.
Joiner
Flat Corner Joiner
Inside or Outside
Corner Joiner
KILOC-JOINER
Kilo Channel Joiner
KILOC-FL JOINER
Kilo Channel Flat Corner Joiner
KILOC-INJOINER
Kilo Channel Inside or Outside
Corner Joiner
KILO Channel
KILO Joiner
KILO Channel
KILO Joiner
KILO Channel
KILO Joiner
0.04”
One each side
