REV1.0 May 27, 2020 1:00 PM
K45R, K45V
- Installation Instructions
Page 2 of 2
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
Please read complete instruction prior to installation and keep for future reference!
Models K45RC-XX & K45VC-XX
1. Product to be installed by a qualified electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
5.1
Remove the paper backing from the adhesive tape on the LineLED before
installing it into the extrusion. Then push the LineLED into the aluminum
extrusion and install endcaps at both ends.
5.2
Snap the diffuser lens into the aluminum extrusion.
5.3
If extrusion going to be installed outside, add silicone to the endcaps & the
full length of the lens. To help avoid getting water inside the extrusion, but
will not make waterproof.
6.1
Ensure the correct (wattage & voltage) power supply is used to power
LineLED. Then proceed to connect LineLED wires from extrusion to power
supply. For more information please refer to power supply and LineLED
wiring instructions.
5
6
5.1
5.2
wire
leads
LineLED
lens
endcap
endcap
with hole
class II power
supply
LineLED of
extrusion
line voltage wires
line voltage wires
6.1
