*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
Page 2 of 5
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
REV0.0 11012019
3
4
3.1
Connect the power feed wire into the one of the female/male connectors that is soldered on the Matrix. By sliding
and then pushing completing into the connector. Secure by placing clip (CL -1) over the connector and secure using
the two screws. Reference diagram below for more details.
- Cool
white
- Warm
white
+ 24VDC
OPTIONAL:
There are 2 additional mounting options, when the adhesive tape is not sticking on to the surface properly. The first and easier solution is to use
push-pins. Only can be used in the areas on the board outlined with a push-pin illustration. The second is to use #0 screw size with an electrical insulating
polypropylene plastic washer 0.065’’ID, 0.188’’ OD. Insert the screw/washer through the Matrix Plus mounting holes to secure Matrix properly to surface.
Matrix Plus
Matrix Plus DW power feed
(part#PF-FC-72-DW-WH )
If Matrix has a male end, carefully
remove the provided 3-pin connector
from the Matrix power feed
connector. Align Matrix power feed
connector with male end of Matrix
and push-in to secure connection.
Matrix power feed connector
can be installed in any
orientation concerning
polarity since the center pin is
positive and the two outer
pins are negative.
Place the clip (CL -1) over the
connector to secure in place
power feed
push-pin
Align Matrix power feed
connector pins with female
end of Matrix and push-in
to secure connection.
Matrix Plus
screw &
washer
Please read all instructions prior to installation and keep for future reference!
1. Product to be installed by a qualied electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
Models MP-DO-DW-22K-60K & MMP-DO-DW-22K-60K
Matrix Plus Dynamic White
-
Installation Instructions
3.1
3.1
4.1
