luminii KMC Series, Инструкция по установке

Страница: 1 / 2

1
KM, KS, KXL & KL Channel -
Installation Instructions
Please read all instructions prior to installation and keep for future reference!
1. Product to be installed by a qualied electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
Page 1 of 2
1.1 Snap the lens into the extrusion, then align & center the extrusion to the
determined location. Then make any reference marks if needed to install
the extrusion, reference step 3 for mounting options.
Note:
Prior to install, 24VDC power must be present for wiring. Also
review and account for all parts necessary to install properly.
Caution:
Safety equipment is recommended, when modifications are being
made to the extrusion & lens.
2.1 Extrusion & lens can be cut in the field. Using the proper blade for
aluminum, cut to the desired length.
2
miter saw
2.1
lens
extrusion
2.1
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
REV0.2 09062018
Models KMC-XX, KSC-XX, KXLC-XX, & KLC-XX
30" maximum spacing
of mounting brackets
mounting brackets
#4 flat head
wood screws
extrusion
STEP A STEP B STEP C
tighten screws below
extrusion surface
before installing LineLED drill through
extrusion for
mounting
holes countersink
the holes
3
flathead screw
1.1
4” 4” every 30”
mounting
bracket
fixture
surface
loosen screws
3.1 Secure the extrusion to the surface by either mounting directly with
screws or using mounting brackets.
Make counter sunk holes through a. If mounting extrusion with screws:
the extrusion followed by screwing directly to the surface.
b. If mounting extrusion with brackets : fixed mounting brackets For ,
install a bracket 4” from each end, followed by installing one every
30”. Then secure, by screwing through the bracket to the surface.
For
, install a bracket 4” from each adjustable mounting brackets
end, followed by installing one every 30”. Then secure, by slightly
loosening the 2 screws on the side of each adjustable bracket.
Then secure, by screwing through bracket to the surface. Then
rotate to the desired position, followed by tightening the side
screws.
MOUNT EXTRUSION
WITH MOUNTING BRACKETS
FIXED BRACKET ADJUSTABLE BRACKET
extrusion
4.0”
30.0”
30.0”
4.0”
30" maximum spacing
of mounting brackets
MOUNT EXTRUSION
WITH SCREWS
install #4 flat head wood
screws a maximum 30"
apart minimum of 2
screws per extrusion.
3.1
3.1
3.1