Page 1 of 2
REV1.3 07052018
1
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
every 20"
2
2.1
Run the lead wires (or DC quick connect cable) through
opening in mounting surface to the remote power supply.
2.2
Mounting surface must to be flat and structurally sound.
Secure each support bracket into the mounting surface with
the appropriate hardware every 20”.
Diffuser lens must be
in the down position.
2.3
Remove the covers on each mounting endcap, orientate two
of the three mounting holes in the up position. Followed by
securing each endcap into the surface. Using the
appropriate hardware.
2.1
1.1
Slide the support brackets into the Kendo Closet Rod extrusion. Must be installed every 20" for
proper weight support distribution.
1.2
Carefully remove the protective film from the diffuser.
1.3
Push the mounting end cap onto each Kendo Closet Rod extrusion end.
3a
1.3
mounting
end cap
power to
24 VDC
Kendo Closet
Rod light fixture
120 VAC
24 VDC
Class II
power supply
drywall
wood block
lead wires
LED
mounting end cap
Please read all instructions prior to installation and keep for future reference!
Kendo Closet Rod
-
Installation Instructions
Models KCR-
2.2
screw
Lead wire power feed
film
1.1
3a
Ensure power is off to power supply! Then proceed to
connect Kendo Closet Rod LED lead wires to power supply.
For wiring instructions please refer to power supply wiring
instructions.
See page 2 - step 4 - for quick connect
power feeding.
See page 2 - step 3b - for quick connect power feeding
3a
support
bracket
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
extrusion
mounting
end cap
screw
2.3
support
bracket
1.2
extrusion
support bracket
extrusion
1
. Product to be installed by a qualified electrician.
2. Must be installed per NFPA 70, article 410.16.
3. Prior to installation ensure power is off at fuse box to prevent electrical shock.
4. Damp locations only.
5. Use only with Class 2 power unit.
6. Suitable for installation within the closet storage space.
7. Max 25 pounds per 6 inch with mounting supports.
