REV1.0 June 12, 2020 11:52 AM
Kendo-45M
- Installation Instructions
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
Please read complete instruction prior to installation and keep for future reference!
Models K45M-XX
1. Product to be installed by a qualified electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
Page 2 of 4
7777 N. Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
1
lead wires
0.75”
0.74”
0.77”
0.75”
0.60”
0.75”
1.1
Determine the location of where the fixture(s) will be installed. Lay the fixture(s) on the surface, and make any necessary reference marks for the
concealed bracket. Make marks 4” from each end of the fixture(s) and also every 30” in between. Use the fixture profile and mounting bracket detail,
for any additional details.
NOTE:
If mounting next to a wall, leave a 0.25” gap. To later remove if needed.
1.2
Lay the concealed bracket onto the reference mark points and secure using the provided hardware.
Kendo 45M,
w/round profile
Kendo 45M,
w/angular profile
1.1
4”
ever
y 30”
fixture
concealed bracket
4”
2
screw
concealed bracket
2.1
Align the mounting brackets to the marks, followed by securing each mounting bracket with 1 screws. Snap the extrusion into the mounting brackets.
2.2
To remove the extrusion from the mounting brackets, carefully insert a flat screwdriver to the bottom edge of the extrusion then pull up until the extrusion
pops up.
