REV3.2
FL Channel -
Installation Instructions
Please read all instructions prior to installation and keep for future reference!
1. Product should be installed by a qualified electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
Page 2 of 2
solder
pads
If required to fit the extrusion length, cut down the Line LED strip
in between two rows of solder pads. Always cut Line LED from
end without connector/wire leads. Ensure that Line LED strip fits
completely
inside the extrusion and the solder pads do not touch
any metal parts as to avoid shorting of circuit.
Line LED strip
wire
leads
8
7
feed wires from line LED
to the power supply
through the hole in the
end cap
endcap
line LED
paper
backing
Once the extrusion is in place, install the line LED strip
by removing backing and pressing on to extrusion.
Then install end caps, and finally snap on the lens.
Remove the protective film from the lens.
lens
9
Ensure power is off to power supply!
Then proceed to connect line LED wires from FL extrusion to
power supply. Connection can be established with lead wires
or quick-connect powerfeed. For more information please refer
to power supply and line LED wiring instructions.
power to Line LED
of FL extrusion
class II
power
supply
line voltage wires
low voltage wires
If you ordered the endcaps that also have
mounting ears, you can use those to attach
fixture to the mounting surface, after it has
been completely assembled (follow previous
instruction steps for assembly).
mounting
brackets
mounting
screws
wires to
power
supply
installation with mounting brackets
6
film
