REV3.2
FL Channel -
Installation Instructions
Please read all instructions prior to installation and keep for future reference!
1. Product should be installed by a qualified electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
Page 1 of 2
STEP A
STEP B
STEP C
1
2
4
3
If required for installation cut down FL extrusion to
desired length with hacksaw or miter saw that has an
appropriate blade for cutting aluminum. Always wear
safety goggles when cutting.
FL extrusion
The FL extrusion can be attached to the mounting surface with
screws or adhesive. These instructions explain how to install the
extrusion using both mounting options (step 4 and step 5).
5
2.06”
0.31”
Use the body of the extrusion and dimensions from step 1
to mark installing position on the mounting surface.
0.66”
0.70”
0.70”
Construction adhesive can also be
used to attach the extrusion to the
mounting surface (instead of screws).
Apply adhesive following instructions
of adhesive manufacturer for material
compatibility and drying time.
construction
adhesive
TYP. 30” O.C.
Ensure the
correct drill bit
is used to drill
in the aluminum
extrusion
Drill location for mounting holes at appropriate in-
tervals and in the middle of the FL extrusion. Follow
steps A,B,C below.
Ensure flathead
screws are tightened
flush with or below
aluminum extrusion
Countersink
holes for
flathead
screws
